ADTRAN Total Access 3010, Системное руководство, Страница: 241 / 511

6TANTP514-1E
TOTAL ACCESS 3000/3010
NTP-514
Page 9 of 12
Perform Steps Below in the Order Listed
Total Access
®
3000/3010 System Manual © 2002, ADTRAN, Inc.
1.) Connect the individual 4-wire HDSL circuits to the HDSL terminal
block inside the Dual slot remote housing. The 4-wire MAIN circuit
will connect to the Loop 1 and Loop 2 terminals labeled “MAIN” and
the 4-wire AUX circuit will connect to the Loop 1 and Loop 2 terminals
labeled “AUX.”
2.) Gently but firmly push the HTU-R into the lower dual slot remote
housing slot. Repeat this step for the second HTU-R in the upper slot.
3.) The HTU-Cs will transfer provisioning data to the HTU-Rs upon power-
up. Some provisioning of the HTU-R, however, may be necessary due to
hardware dipswitches and jumpers. See the Installation and Maintenance
practice for the specific HTU-R utilized by your company.
4. Upon provisioning of the HTU-Rs, the faceplate LEDs should read as shown in
Table 3.
Table 3. Faceplate LED Indications
) N I A M ( C - U T H
n e e r G g n i h s a l F w o l S - R W P
n O - X S D
f f O - T S T
n e e r G - 2 P L , 1 P L
d e R - M L A
n e e r G - T C A
) X U A ( C - U T H
n e e r G g n i h s a l F w o l S - R W P
n O - X S D
f f O - T S T
n e e r G - 2 P L , 1 P L
f f O - M L A
f f O - T C A
) N I A M ( R - U T H
n e e r G - 2 P L , 1 P L
f f O - 1 S D
d e R - M L A
n e e r G r o w o l l e Y - F S / F S E
n e e r G r o w o l l e Y - I M A / S Z 8 B
f f O - K B L
) X U A ( R - U T H
n e e r G - 2 P L , 1 P L
f f O - 1 S D
d e R - M L A
n e e r G r o w o l l e Y - F S / F S E
n e e r G r o w o l l e Y - I M A / S Z 8 B
f f O - K B L