ADTRAN NetVanta 1224STR PWR, Руководство по установке оборудования

Страница: 37 / 48

NetVanta 1224STR DC Hardware Installation Guide Unit Installation
61200590E1-34B Copyright © 2013 ADTRAN, Inc. 37
Wall Mounting the NetVanta
By following these instructions exactly, the NetVanta can be safely mounted to the wall.
Figure 15. Wallmount Installation
• To avoid damaging the unit, use only the screws included in the shipment when
attaching mounting ears to the chassis.
• When wall mounting the NetVanta, care must be taken not to damage the power cord.
Do not attach the power cord to the building surface or run it through walls, ceilings,
floors, or openings in the building structure.
• The socket-outlet must be installed near the equipment and must be easily accessible.
Instructions for Wall Mounting the NetVanta
Step Action
1 Remove the mounting ears. Rotate them 90 degrees so that the portion of the bracket with the
mounting holes is flush with the bottom of the chassis. Reattach the mounting ears to the
chassis (see
Figure 15 ).
2 Decide on a location for the NetVanta. Keep in mind that the unit needs to be mounted at or
below eye-level so that the LEDs are viewable.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two #6 to #10 (1 inch or greater in
length) wood screws through the unit’s brackets and into the mounted board (see
Figure 15 ).
5 Proceed to the steps given in Supplying Power to the Unit on page 38 .