Adtech CNC9 Series, Руководство по обслуживанию

Страница: 58 / 249

ADTECH9 Series CNC Maintenance Manual
- 53 -
7. Program saving & editing
7.1 Saving the program in the memory
7.1.1 Keypad input (new program)
Create new program in the memory with the keypad, and the steps are as follows:
In the main menu, press [Edit] to enter program edit interface;
Press [File] to enter file operation interface;
Select [New] to create a new file;
Enter the file name and press [EOB] to confirm and create a new program in current directory in the memory,
and load into the system by default;
Select [Close] to exit [Edit] interface;
In edit mode, enter the program content;
After editing all programs, press [Reset] to save the edited programs into the system memory.
7.1.2 Computer network access/serial port input
Connect the controller to the router with a network cable.
Through built-in command window, it is available to view the local computer ip address configuration using the
IPCONFIG command, as shown below:
Assign the controller the IP address 192.168.2.10 in the same network segment that is not used based on the IP
address of the host computer, for example, the IP address is 192.168.2.54.