– 6 –
REPLACING THE BATTERY IN A WALL MOUNTED KEYPAD
1.
Remove the retaining screw at the bottom of the Keypad.
2.
Press upward with your thumbs on the bottom edge of the Keypad housing and slide the Keypad up with
respect to the wall mounting plate, removing the Keypad from the wall mounting plate.
3.
Remove the power harness on the old battery pack that connects to the printed circuit board.
4.
Lift the old battery pack from the Keypad and replace with the new battery pack.
5.
Connect the power harness to the printed circuit board.
6.
Replace the Keypad onto the wall mounting plate and secure with the retaining screw.
NOTE:
After replacing the battery and reattaching the Keypad to the mounting plate, enter the 4-digit
security code + OFF sequence twice to clear any trouble condition.
REPLACING THE BATTERY IN A DESK MOUNTED KEYPAD
1.
Place the Keypad face down on a level surface.
2.
Remove two screws and lift up Desk Stand up and away from the Keypad to expose the battery pack.
3.
Remove the power harness on the old battery pack that connects to the printed circuit board.
4.
Lift the old battery pack from the Keypad and replace with the new battery pack.
5.
Connect the power harness to the printed circuit board.
6.
Place the tabs on the Desk Stand into the appropriate slots and secure with two screws.
NOTE:
After replacing the battery and reattaching the Keypad to the mounting plate, enter the 4-digit
security code + OFF sequence twice to clear any trouble condition
.