ITC8113 / TabX®
52
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
Fastening the docking station to the stand / wall bracket
Tighten the screws contained in the scope of delivery as shown in the picture.
Screws: M5x25, DIN 7991, strength 8.8, Allen key 3 mm, torque 1 Nm.
Fastening the bracket to a table or a wall
Use adequate screws and plugs depending on the load-bearing capacity of the supporting
surface of the table or wall for safe mounting. The type of screw connection required (e.g.
number, diameter, quality, type and length of screws and any special wall plugs or anchors
required) depends largely on the fastening interface provided by the customer (e.g. on a steel
plate, wooden plate or plasterboard). In case of doubt, have all necessary calculations carried
out by an experienced designer.