[Sentry Trailer – Operation, Startup, and Shutdown Procedures]
As an alternate, the Model GA-1 or GA-2 helical screw type guy anchors or CGA-1680 concrete
type ground anchors can be used.
3. The tow vehicle must now be uncoupled from the unit.
a. Remove the safety pin and unlatch the coupler. Either swivel and lock the front tongue
jack into the useable position and crank it down so the tow vehicle can be moved away
(see Fig. 1A) OR pull the pin on the dropleg jack and allow the leg to drop to its lowest
position.
b. Realign the through holes and reinsert the pin. Crank it down so the tow vehicle can be
moved away (see Fig. 1B).
c. Disconnect the safety chains, light connector cable, and breakaway cable from the tow
vehicle.
4. Remove the two hitch pins that hold the rear “outriggers” in the stowed position.
a. Carefully pull them out until the second set of pinholes is visible.
b. Then, reinsert the pins with the outriggers in the extended position (see Fig. 5).
c. Repeat for the front “outriggers”.
5
