Industrial PCs OPC5012
8
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
2
S
AFETY INFORMATION
The device is electrically charged and contains highly sensitive components. Permissible
modification by the user is limited to installing add-on cards. The manufacturer or a service
provider authorized by the manufacturer should be consulted if any other modifications are
to be carried out. Whenever such modifications are carried out the device must first be
switched off and the power cable must be disconnected. The appropriate measures should
be implemented to avoid electrostatic shock to the components upon contact. Opening of
the device by a non-authorized person could result in hazards to the user and renders any
warranty claims invalid.
General notice:
•
The manual should be read by all users and should be kept readily accessible at all
times.
•
Mounting, startup and operation should only be carried out by trained personnel.
•
All persons using the device should observe the safety information and the
manual.
•
The rules and regulations pertaining to accident prevention should be observed in
the place of device installation.
•
The manual contains the most important information required for safe operation of
the device.
•
Proper storage, transport, installation and startup are required to ensure correct
and safe device operation.
Warning:
The device should be switched off prior to connecting any cables (power supply,
peripherals) to prevent damage to the device.
2.1
P
LACE OF INSTALLATION
The control system is intended for installation in the control cabinet. The specified ambient
conditions should always be adhered to. Use in non-specified environments (e.g. on boats,
in explosive hazard areas or at extreme altitudes) is prohibited.
Warning:
In order to avoid formation of condensation, the device should only be switched on once
it has acclimated to the room temperature. The same applies if the device has been
exposed to extreme variations in temperature.
Preventing overheating during operation: The device should not be exposed to direct
sunlight or other sources of light.
Measures to prevent heat accumulation should be implemented if the device is installed
in a console, casing or similar enclosing structure. The maximum permissible ambient
temperature should not be exceeded.
