ADRF PSR-78-9537, Руководство пользователя

Страница: 23 / 48

Advanced RF Technologies, Inc. 23
3. ALARMS
3.1 Message Board Alarms and Notifications
Table 3-1 Message Board Alarms and Notifications
Parameters Remark
AC Fail AC Input is outside of operating range
DC Fail DC Output is outside of operating range
Temperature Module is above/below the normal operating temperature
Current PSU is providing more than the max current
System Halt System is in a shutdown state due to a hard fail alarm
DSP Fault System has detected an issue with the internal DSP
OSC Oscillation detected
DL Signal not detected DL signal is below the specified level
DL Signal Low DL signal is below the specified level
Input Overload Incoming in-band DL or UL signal is too strong
Out of band Overload Incoming out-band DL or UL signal is too strong
Synthesizer Lock Fail Issue with internal PLL
DL RF Power Input + gain does not match the output level (above delta of 6 dB)
Overpower Output level is above the max output levels
VSWR Power is being reflected back to the repeater
Heartbeat Heartbeat is sent out to the NOC
Reboot Soft reboot performed
Factory setting Factory default settings restored
Door Door alarm set/clear
3.2
Alarms
Table 3-2 Alarms
Parameters Remark
AC Fail Power supply is not operating within specs. (4 seconds)
DC Fail Power supply is not operating within specs. (4 seconds)
Temperature
Module is above the normal operating temperature. (4 seconds)
Over Temperature [Soft: 80~87 C, Hard: Above 87 C]
Current
Power supply is not operating within specs. (4 seconds)
Over Current [Hard: Above 20A]
System Halt System is in a shutdown state due to a hard fail alarm. (10 cycles)
DSP Fault
System has detected an issue with the internal DSP chip. (Cannot
communicate with DSP)
OSC Oscillation detected.
DL Signal not Detected DL signal is below the specified level. (default: -90dBm, 4 seconds)
DL Signal Low DL signal is below the specified level. (default: -85dBm, 4 seconds)
Input Overload
Input signal is above the threshold. (4 seconds)
(Soft: DL -5dBm/UL -5dBm, Hard: DL +5dBm/UL +5dBm)
Out of Band Overload
Out of band signal is above the threshold. (4 seconds)
(Soft: DL +3dBm/UL +3dBm, Hard: DL +5dBm/UL +5dBm)
Synthesizer Lock Fail Issue with internal PLL. (4 seconds)