41124 Children's Gazebo.ZZZ-212.0918-15.EFS.doc
2
Safety Instructions
1.
Do not attempt to assemble the screenhouse under
windy conditions.
2.
In the event strong winds or storms are forecasted,
disassemble and store in a safe place. Minimum
precaution requires removal of the roof.
3.
While this screenhouse meets CPAI Code 84
requirements for flame retardancy, it is NOT fire proof.
Keep open flames and flammable materials outside and at
a safe distance from your screenhouse.
1.
Prior to assembly
A.
To safely and easily assemble the screenhouse a
minimum of two people are needed. You will need
screwdrivers, a nut driver, an adjustable wrench, and a
power drill.
B.
You should erect your screen room on as level and
solid a base as possible.
C.
Remove the vinyl roof, roof tubes, vinyl hinges and
the door hardware and inventory parts as listed on page 9
for your model.
2.
To assemble the wall
A.
The panels come pre-attached with vinyl hinges in the
box. Form a rough square with screening on the outside
like a diagram, making certain center bars are inside the
room.
B.
Position the empty door frame where you desire the
door.
C.
Line up the edge of the two end frames.
D.
While holding one end of the vinyl hinge vertically
above the two frames, slowly insert it simultaneously into
both frames until completely inserted.
3.
Door installation
To install as pre-assembled in factory, take the (14-030)
plastic tracks from the box and slide them onto the
extrusion at the top and bottom of the door opening. The
open side should face down for the top track (2 holes) and
up for the bottom track (no holes).
A.
Slide door into position. Make sure the wheels are at
the bottom and the screen towards the outside of the
room, then drill two holes for the handles (85-050) at the
height you desire.
B.
Install weather strip (85-058) on both 60’’ vertical
sides of the door frame, facing inwards.
4.
Frame fixture
Take brackets (94-233 or 94-219) and screw onto top
corners between each pair of frames. The screws that fall
within the closed position and travel of the door must be
screwed on from the inside out, so as not to impede its
movement (3 screws total).
5.
To assemble roof
A.
One person should be on a stool or stepladder in the
center of the screen room holding the 6-finger hubs (88-
105) that will join the tubing.
B.
A second person should take the tubes in order as per
the diagram below. Place one end of a tube on the hub,
insert a tube tip into the other end of the tube, and place
the tube tip through the corresponding bracket, as shown
in the picture.
1
26 1/2”
2
42”
3
32 1/4"
4
49 3/4"
2
4
4
3
3
2
2
2
4
4
1
41124
3
3
