ADLINK Technology Q7-BT, Техническое описание

Страница: 27 / 50

Interfaces 21
Q7-BT
91 USB_CC (USB Client Connect pin. If
USB Port 1 is configured for client mode,
then an externally connected USB host
should set this signal to high-active in
order to properly make the connection
with the module's internal USB client
controller. If the external USB host is
disconnected, this signal should be set to
low-active in order to inform the USB
client controller that the external host has
been disconnected. A level shifter/
protection circuitry should be
implemented on.) 92 USB_ID (USB ID pin. Configures the mode
of the USB Port 1. If the signal is detected
as being 'high active' the BIOS will
automatically configure USB Port 1 as USB
Client and enable USB Client support. This
signal should be driven as OC signal by
external circuitry.)
93 USB_OTG- (USB client) 94 USB_P0- (Universal Serial Bus Port 0
differential pair.)
95 (USB client) 96 (Universal Serial Bus Port 0
differential pair.)
97 GND 98 GND
99 e (option) /
(LVDS primary channel differential pair 0.
Embedded Display Port primary channel
differential pair 0.)
100 (LVDS secondary channel
differential pair 0.)
101 eDP0_TX0- (option) / LVDS_A0-
(LVDS primary channel differential pair 0.
Embedded Display Port primary channel
differential pair 0.)
102 LVDS_B0- (LVDS secondary channel
differential pair 0.)
103 e (option) /
(LVDS primary channel differential pair 1.
Embedded Display Port primary channel
differential pair 1.)
104 (LVDS secondary channel
differential pair 1.)
105 eDP0_TX1- (option) / LVDS_A1-
(LVDS primary channel differential pair 1.
Embedded Display Port primary channel
differential pair 1.)
106 LVDS_B1- (LVDS secondary channel
differential pair 1.)
107 e (option) /
(LVDS primary channel differential pair 2.
Embedded Display Port primary channel
differential pair 2.)
108 (LVDS secondary channel
differential pair 2.)
109 eDP0_TX2- (option) / LVDS_A2-
(LVDS primary channel differential pair 2.
Embedded Display Port primary channel
differential pair 2.)
110 LVDS_B2- (LVDS secondary channel
differential pair 2.)
111 LVDS_PPEN (Controls panel power
enable.) 112 LVDS_BLEN (Controls panel backlight
enable.)
113 e (option) /
(LVDS primary channel differential pair 3.
Embedded Display Port primary channel
differential pair 3.)
114 (LVDS secondary channel
differential pair 3.)
Table 3-1: Q7 Interface (GF1) Signal Descriptions (Continued)
Pin # Primary (Top Side) Pin # Secondary (Bottom Side)