ADLINK Technology NuPRO-860 Series, Руководство пользователя

Страница: 35 / 54

Getting Started 27
3 Getting Started
This chapter gives a summary of what is required to set up an
operating system using the NuPRO-860. Hardware installation
and BIOS setup are also discussed. Note that the NuPRO-860 is
shipped with CPU, and RAM preinstalled. Installation of the CPU
and RAM are performed at the ADLINK factory and the proce-
dures described in the following sections are for user reference. If
the default configuration does not suit your application needs, con-
tact a local ADLINK dealer for special configurations or OEM ver-
sions.
3.1 CPU Installation
The NuPRO-860 supports the Intel® Pentium® M processors. If
the required CPU module is pre-installed when the product is
received, this section may be skipped.
First remove the heatsink from the EM-64 CPU Module by remov-
ing the four screws as shown in
Figure 3.1: Heat Sink Installa-
tion . Replace the screws to secure the EM-64 CPU Module to the
carrier board.
The CPU socket is located on the EM-64 CPU Module as shown
in
Figure 3.2: CPU Installation below. Remove the CPU from its
packaging and place it carefully in the CPU socket as shown. Be
sure to align the gold triangle on the corner of the chip with the
corner of the socket that is missing a pin. Press down gently on
the chip to ensure that it is securely in place, and then use a small
flathead screwdriver to rotate the CPU lock clockwise and lock the
CPU into position.