Interfaces
21
LEC-BTS
Note: The # symbol indicates the signal is Active Low.
P153
VDD_IN (Module power input voltage -
5V)
S154
CARRIER_PWR_ON (Carrier board circuits
[apart from power management and power
path circuits]
are
powered up until the
Module asserts the CARRIER_PWR_ON
signal)
P154
VDD_IN (Module power input voltage -
5V)
S155
FORCE_RECOV# (Low on this pin allows
non-protected segments of Module boot
device to be rewritten / restored from an
external USB Host on Module USB0. The
Module USB0 operates in Client Mode when
the Force Recovery function is invoked.
Pulled high on the Module. For SOCs that
do not implement a USB based Force
Recovery function, then a low on the Module
FORCE_RECOV# pin
may
invoke the SOC
native Force Recovery mode – such as over
a Serial Port. Pulled up on Module. Driven
by OD part on Carrier.)
P155
VDD_IN (Module power input voltage -
5V)
S156
BATLOW# (Battery low indication to
Module. Carrier to float the line in inactive
state. Pulled up on Module. Driven by OD
part on Carrier.)
P156
VDD_IN (Module power input voltage -
5V)
S157
TEST# (Held low by Carrier to invoke
Module vendor specific test function(s).
Pulled up on Module. Driven by OD part on
Carrier.)
S158
GND
Table 3-2: SMARC P-S Connector (GF1) Signal Descriptions (Continued)
Pin #
Primary (Top Side)
Pin #
Secondary (Bottom Side)
