6.2 BOOST CHARGING
- Select charging voltage and assemble the cable to 12V or 24V socket.
-
Select charging mode switch "C” in „BOOST” position (lower).
- Select charging mode switch "B" in BOOST (boost charging in ca. 10-15 min).
-
Adjust main switch ‘’D” in ON pos and start charging.
6.3 SIMULTANEOUS CHARGING OF SEVERAL BATTERIES
If you have to charge more than one battery at the same time, you can connect them “in series” or “in
parallel. For “parallel” connection batteries must have the same nominal voltage (Volt), which
corresponds to the battery charger output voltage, and the total of Ah must be within the charge range
of the battery charger. For “serial” connection, batteries must have the same capacity (Ah) and the sum
of the nominal voltages of all the batteries must correspond to the battery charger output voltage.
WARNING!
In serial connection of two 12V batteries, switch charging voltage to 24V.
Parallel connection Serial connection
6.4 END OF CHARGE
- Remove the power supply from the battery charger by turning the switch to OFF and/or removing the
power supply cable from the mains outlet.
- Disconnect the black charge clamp from the chassis of the vehicle or from the negative terminal of
the battery (- symbol).
- Disconnect the red charge clamp from the positive terminal of the battery (+ symbol).
- Store the battery charger in a dry place.
7. STARTING THE ENGINE
WARNING: Before proceeding with starting,
follow the vehicle manufacturer’s instructions carefully!
Make sure the power line is protected by fuses or automatic circuit breakers with sizes as indicated on
the rating plate.
You can start your vehilce with this bartery charger if your battery does not have enough energy to start
the engine by itself. You can use the power supply, selecting the mode switch
to “starting” position.
Make sure the battery is connected properly to the respective (+ and -) terminals, and that it is in good
condition (not sulphated or dud). Never ever start vehicles with the batteries disconnected from their
respective terminals; the presence of the battery is essential for the elimination of possible overvoltage.
With the battery charger at OFF, plug in the power cable.
- Turn the switch ON.
- Turn the switch to START and turn the ignition key to start up the engine.
If the engine does not start within a few seconds, switch back to BOOST mode. After one minute take
on starting again.
Содержание START-40/1
Страница 1: ......
