ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 9
ADJ Products, LLC - www.adj.com - Revo 4 IR Instruction Manual Page 8
Revo 4 IR
System Menu
System Menu: When confirming your setting press ENTER and
then hold MENU for at least 2-3 seconds, or you can wait 1
minute for automatic setup. To exit without making any adjust-
ments press the MENU button.
ADDR -
DMX Address Setting
.
1. Press the MENU button until “ADDR” is displayed, press ENTER.
2. The current DMX address will now be displayed and flashing.
Press the UP or DOWN buttons to find your desired address. Press
ENTER to set your desired DMX address.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least 3
seconds.
CHND -
This will let you switch between 4 Channel DMX
mode and 256 Channel DMX mode.
1. Press the MENU button until “CHND” is displayed, press ENTER.
Either “4CH” or “256C” will be displayed
2. Press the UP or DOWN buttons to choose your desired DMX mode
and press ENTER to confim and exit.
SLND -
This will let you set unit as a master or slave in
a master/slave configuration.
1. Press the MENU button until “SLND” is displayed, press ENTER.
“MAST”, “SL 1” or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim and exit.
SHND: SH 1
-
SH 12
- Show modes 0 - 12
Show Mode can run with or without sound active mode on.
With sound active mode on, the shows will tend to run faster.
1. Press the MENU button until “SHND” is displayed, press ENTER.
2. “Sh X” will now be displayed, “X” representing a number between
Revo 4 IR
System Menu