ADJ Products, LLC - www.adj.com - Monster Quad Instruction Manual Page 11
show and press ENTER to confirm. After pressing ENTER, press
and hold the MENU button for at least 3 seconds to activate.
Sound State
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound State” is displayed, press
ENTER.
2. Either “On” or “Off” will now be displayed. Use the UP or
DOWN buttons to toggle between “On” and “Off”.
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
- This function will let you adjust the
sound sensitivity of the sound active mode.
1. Press the MENU button until “Sound Sense” is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (least sensitive)
and 100 (most sensitive).
3. Press ENTER to set you desired level.
DMX State
-
This mode is used as a precaution mode.
In case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “DMX State” is displayed, press
ENTER.
2. Either “Master/Slave”, “Blackout”, or “Last State” will be dis-
played. Choose an operating mode you would like the unit to
start up in when either power is applied or the DMX signal is lost.
Monster Quad
System Menu
ADJ Products, LLC - www.adj.com - Monster Quad Instruction Manual Page 10
Monster Quad
System Menu
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
DMX Address
-
Set the DMX Address -
1. Press the MENU button until “DMX Address” is displayed,
press ENTER.
2. “XXX” will now be displayed, “XXX” represents the displayed
address. Press the UP or DOWN buttons to find your desired
address.
3. Press ENTER to confirm, and then press and hold the MENU
button
for at least three seconds
to assign.
Slave Mode -
This will let you set the unit as a slave in
a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed,
press ENTER. Either “Slave 1” or “Slave 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to “Slave 2”, the
fixtures will now have contrast movement to each other.
Show Mode
- Show modes 0 - 12 (Factory Shows).
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number
between 0-12. Shows 1-12 are preset shows, while “Show 0” is
random show. Press the UP or DOWN buttons to find your desired
