ADJ COB CANNON WASH, Инструкция пользователя

Страница: 26 / 31

MULTIPLE UNIT POWER LINKING
With this feature you can connect the fixtures to one another using the power cable input and output
sockets.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES AS THE POWER CONSUMPTION
OF OTHER MODEL FIXTURES MAY EXCEED THE MAX POWER OUTPUT ON THIS FIXTURE!
CHECK SIL SCREEN FOR MAX AMPS.
PRIMARY SECONDARY SETUP
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units. Remember that the Male XLR connector is the input and the Female XLR
connector is the output. The first unit in the chain (primary) will use the female XLR connector only.
The last unit in the chain will use the male XLR connector only.
2. Set the “Primary” unit to your desired mode of operation.
3. On the “Secondary” units press the MODE button until “SECd” is displayed. Each “Secondary” unit
must be set to the same setting.
4. Connect the first “Secondary” unit to the “Primary.” The “Secondary” unit(s) should now start
following the “Primary” unit.
OPTIONAL LENS CHANGE
The COB Cannon Wash comes with an 80-degree lens already attached. Included in the box are optional
40 & 50-degree lenses. To switch lenses simply remove the retainer ring located in front of the current
lens. After the retainer ring has been removed carefully remove the lens, and attach your desired lens.
Reinstall the retainer ring and the switch is complete. When reinstalling the retainer ring, make sure to
insert 3 points of the retainer ring into the 3 notches located around the inside of the lens frame.
FUSE REPLACEMENT
Disconnect the unit from its power source. Remove the power cord from the unit. Once the cord has been
removed, the fuse holder is located under the powerCON connection. Use a Phillips head screwdriver
to remove the fuse holder. Remove the fuse located inside the fuse holder and replace with the new
fuse. Install the fuse holder and new fuse and secure it.
CLEANING
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried
out periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue,
dust, dew).
26