ADJ COB CANNON WASH, Инструкция пользователя

Страница: 15 / 31

15
DMX Mode: Operating through a DMX controller gives the user the freedom to create their own programs
tailored to their own individual needs. Press the MODE button to select the DMX mode.
DMX Addressing and Channel Mode: This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller. (When a DMX Address is set, the LED display will flicker
if there is no signal from the controller.)
1. To run your fixture in DMX mode, press the MODE button until “d.XXX” is displayed. “XXX” represents
the current displayed DMX address.
2. Use the UP or DOWN buttons to select your desired DMX address, then press the SET UP button
to select your DMX Channel mode.
3. Use the UP or DOWN button to scroll through the DMX Channel modes (Ch03, Ch04, Ch05, Ch06,
Ch07, Ch09, and Ch10).
No DMX Setup: This mode allows the unit to default to one of three modes if the DMX signal is
lost or interrupted.
1. Press the SET UP button to select your setting.
2. Press the UP or DOWN button to select one of the three options.
BLACKOUT = “blAc”. The unit will switch all LED’s off if signal is lost.
HOLD = “LASt”. The unit will hold the last state before the signal was lost.
AUTO = “ProG”. The unit will run the default internal programs.
Delay Mode: Select the unit delay mode by pressing the SET UP button until “dr-X” is displayed. Press
the Up or Down button to set the delay rate 0-4. After you have chosen your desired DMX Channel
mode, plug in the fixture via the XLR connections to any standard DMX controller.
Secondary Mode: Press the MODE button to select the Secondary Mode.
Secondary mode will be displayed as “SECd”.
Note, while in Secondary mode, the SET UP, UP and DOWN buttons will not function.
Manual Dimmer Color Mode: Press the MODE button to select the manual Dimmer Color Select
mode. The Color Red will be displayed as “r.XXX” with “XX” representing the dimming rate of 0-255.
1. Press the SET UP button to select a different color; green “GXXX”, blue “bXXX” or amber “AXXX”.
2. Press the Up or Down button to set the dimming rate 0-255.
Flash Speed Select: Press MODE button to select the Flash Speed Select mode.
Flash Speed will be displayed as “FS.XX” with “XX” representing the flash speed rate.
1. Press the SET UP button to adjust the desired flash speed.
2. Press the Up or Down button to set the speed between “FS.00” (flash off), “FS.01” (slowest flash)
and “FS.15” (fastest flash).