ADIC LTO 200D, Руководство пользователя

Страница: 39 / 65

Troubleshooting and Diagnostics 27
Notes
If the function requires you to insert a cartridge,
c
will appear on the single-character
display. Within 60 seconds, insert a cartridge or the drive will exit Maintenance Mode.
If you insert an invalid or write-protected cartridge, a blinking
7
will appear on the
single-character display and the Status LED will be flashing amber and the LCD will
display ERROR! Media Error after the drive loads the tape. After several seconds the
drive will then unload the cartridge and exit Maintenance Mode.
If the function is successfully completed,
0
appears temporarily on the single-character display and the drive exits
Maintenance Mode .
If the function fails, the Status LED will flash amber, an error code will be shown on the single-character display, and
the drive exits Maintenance Mode . To resolve an error refer to Table 4-2 Error Codes, elsewhere in this chapter.
To clear an error, cycle (remove, then reapply) power to the LTO standalone.
Exit Maintenance Mode
To select the Exit Maintenance Mode function, perform the following steps:
1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
The front panel indicators will display the following:
Indicator State, Character, or Message
Status
LED Amber, solid
Single-character display
0
LCD
Maint Mode: Select
Exit Maint Mode
2. With
0
on the single-character display, press and hold the Unload button for three seconds to force the drive to exit
Maintenance Mode (the Status LED is solid green).
The drive also exits Maintenance Mode automatically after it has completed a function or after 10 minutes if no action
has occurred.
Drive R/W Diagnostic
Use this function to direct the drive to execute built-in tests to determine whether it can properly load and unload cartridges, and read and
write data.
To select the Drive R/W Diagnostic , perform the following steps:
1. Verify that the drive is in
Maintenance Mode
shown when the
Status
LED is solid amber.
2. Press the Unload button once per second until the front panel indicators display the following:
Indicator State, Character, or Message
Status LED Amber, solid
Single-character display
1
LCD
Maint Mode: Select
Drive R/W Diagnostic