ADIATEK ruby 45, Использование и обслуживание

Страница: 12 / 21

12
ADJUSTING THE SQUEEGEE HEIGHT
The squeegee must be adjusted in height depending on the rubber
wear. In order to guarantee a perfect drying during the operation, the
lower blade of the rear squeegee rubber (4) must work slightly bent
backwards (operator side) in uniformed way in all its length.
Acting clockwise upon the two registers (5) it is possible to increase
the bending of the rubber. Acting counterclockwise it is possible to
decrease the rubber bending.
A label placed near the two registers (5) indicates rotation sense to
increase or reduce the height.
Note: The wheels of the squeegee support must be adjusted through
the registers (5) at the same height so that the squeegee works
parallel to the floor.
ADJUSTING THE SQUEEGEE INCLINATION
In case of need, to increase the rubber bending in the central part, it
is necessary to tilt the squeegee rotating counterclockwise the
register (6). To increase the rubber bending on the squeegee
extremities, rotate the register clockwise.
SPLASH GUARD ASSEMBLING
SPRING-LOCKING TYPE
The two splash guards have to be assembled onto the brushes base
group. Insert the metal strips inside the suitable slots present on the
rubber. Place the round hole at the flat extremity of the strip onto
the screw placed in the front part of the brushes base group. Secure
the strips through the nut blocking it.
Hook the coupling in the rear part of the brushes base group to the
slot placed at the extremity of the metal strip still free. Please act as
above for both the splash guard rubbers, paying attention to reduce
to the minimum the gap between the two rubbers in the front part of
the brushes base group.
With brushes assembled, the splash guard must slightly touch the
floor.
KNOB-LOCKING TYPE
The two splash guards have to be assembled onto the brush base
group. Insert the metal strips inside the suitable slots present on the
rubber. Place the round hole at the flat extremity of the strip onto
the screw placed in the front part of the brush base group. Secure the
strips through the nut blocking it.
Screw down the knobs in the rear part of the cover in the free
extremity of the metal strips. The operation has to be carried out for
both splash guards.
With the brush assembled, the splash guard must slightly touch the
floor.
BRUSH/ES ASSEMBLY AND DISASSEMBLY
1. Take off the electric supply to the brush motor unplugging the
batteries connector.
2. Acting upon the pedal lift the brush base group.
3. With the brush base group in lifted position, insert the brush
into its plate seat underneath the brush base turning it until the
three metal buttons are properly seated in their slots; rotate
energically the brush to push the button towards the coupling
spring until it gets blocked.
The figure shows the rotating sense for the brush coupling.
SINGLE BRUSH VERSION