ADIATEK ruby 45, Использование и обслуживание

Страница: 11 / 21

11
BATTERIES CHARGING
Take the machine to a levelled surface.
Plug in batteries connector (1) placed in the rear part of the machine,
to connector (2) of the battery recharger.
ON-BOARD BATTERY RECHARGER (OPTIONAL)
If the machine is equipped with the on-board battery recharger (see
under "OPTIONAL ACCESSORIES”) please refer to the instructions of
the constructor of this accessory what the recharging operations
concern.
The battery recharger is connected directly to the battery poles.
During the recharging operations a device is activated which does not
permit the machine's functioning.
The main cable of the battery recharger has a maximum length of
two meters (6.5 ft.) and must be connected to a single-phase socket
type CEE 7/7.
BATTERIES CHARGING WITH ON-BOARD BATTERY CHARGER
(OPTIONAL)
Bring the machine on a leveled surface near to a single-phase socket
(within 2m, 6.5 ft.) with tension 230V, frequency 50Hz (for USA 120V,
60Hz), nominal current 10A.
Switch off the switches of the brushes motor, suction motor and of
the solenoid valve.
Insert the plug into the mains socket.
At the end of the recharging, take off the plug from the mains
socket.
BATTERIES CHARGE LEVEL INDICATOR
If the machine is not provided with a display
, when switching on
the signal lamp of the battery charge level (2) will come on.
When the signal lamp is in
green colour
it means that the battery
charge level is sufficient for the functioning of the machine.
If the signal lamp is in
red colour
it means that the battery charge
level is insufficient for the functioning of the machine and it is
necessary to recharge immediately the batteries (see under
"BATTERIES CHARGING”).
If the machine is equipped with a display, on the display (1) the
following indication of the battery charge level is digital and
indicates the percentage of the battery charge. 100 is the maximum
charge, down to a minimum of 10, indicating every 10% decrease.
When the charge level reaches 20%, the display starts blinking
indicating the end of the battery charge.
After a few seconds from the four blinking ‘’----’’ dashes, the brushes
motor stops automatically. With the remaining charge it is anyhow
possible to finish the drying operation before proceeding to the
recharge.
HOUR METER (IF EQUIPPED WITH A DISPLAY)
The machine is equipped with an hour meter located on the same
display of the battery charge level indicator (1). Keeping the button
(2) pressed for more than 3 seconds, the first data indicates the
working hours and after a few seconds the working minutes are
shown.
SQUEEGEE ASSEMBLING
With the squeegee support lowered, slide the two stud bolts (1)
placed on the upper part of the squeegee inside the slots on the
support. Block the squeegee by rotating the lever (2) clockwise.
Insert the squeegee hose (3) into its coupling, respecting its position
as indicated in the figure.