ADIATEK 48907050, Использование и обслуживание

Страница: 12 / 18

GB GB
12
SIDE BRUSH
The machine is equipped with a side brush that per-
mits to clean near the right side borders.
The function is activated acting upon the switch (13)
both in manual as in automatic mode. The signal
lamp (25) indicates that the side brush is active and
in working position.
WORKING ADJUSTMENTS
Both in automatic as in manual mode, during the
first metres check:
1. that the adjustment of the detergent solution
flow is sufficient to wet the floor uniformly avoiding
the leakage of detergent from the splash guards (see
under paragraph “FLOW ADJUSTMENT OF THE DE-
TERGENT SOLUTION”).
2. that the squeegee adjustment guarantees a per-
fect drying result (see under paragraph “ADJUST-
MENT OF THE SQUEEGEE”).
3. that the brushes pressure permits an efficient
washing action in function of the dirt and the speed
(see under paragraph “ADJUSTMENT OF THE BRUSH-
ES PRESSURE”).
FLOW ADJUSTMENT OF THE DETERGENT SOLU-
TION
To adjust the detergent solution quantity that flows
down onto the brushes it is necessary to act upon
the solution valve knob (10) placed on the upper
part of the side instrument board, rotating counter-
clockwise to increase it and clockwise to reduce it up
to closure of the flow.
The side brush has an independent water flow ad-
justment, with a solution valve (11) placed under the
frame near the brush itself.
Please remember that the side brush does not have a
scrubbing function but simply moves the dirt to-
wards the center of the machine.
ADJUSTMENT OF THE BRUSHES PRESSURE
Both in automatic as in manual mode it is possible
through the selector (4) to adjust the brushes pres-
sure on the floor in eight established levels. During
the operation, we can visualize on the display (1) the
value in percentage of the electric absorption of the
brushes motor by pressing the button (3).
ATTENTION:
In order not to overload the brushes motor, it is con-
venient to reduce the brushes pressure going from
smooth floors to rough ones (ex. concrete).
The presence on the display (1) of a blinking warning
from P2 to P8 indicates that the pressure level set
determines an overload of the brushes motor. It is
therefore necessary to reduce the pressure up to the
level where the blinking warning stops.
ELECTRIC PROTECTION
The machine is equipped with an electronic system
of protection for all components that carry out
functions of power or control. This device blocks the
defective component and indicates on the display (1)
the corresponding alarm from ”AL01” to “AL20”.
The last two figures indicate the number of the
alarm code.
ATTENTION:
To restore the functioning of the component,
turn off and on again the machine acting upon
the key switch. If the problem persists, please
contact the authorized technical assistance.
OVERFLOW DEVICE
In order to avoid serious damages to the suction mo-
tors, the machine is equipped with a float that inter-
venes when the recovery tank is full, closing the suc-