Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
Modbus TCP Master / KNX
Document code: MN67814_ENG Revision 1.003 Pagina 15 di 27
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, KNX and Modbus TCP.
By Pressing the “
Set Communication
” button from the main window for SW67814 (Fig. 2) the window
“Set Communication” appears (Fig. 3).
The window is divided in two sections, one for the KNX and one for the Modbus TCP.
The means of the fields for “KNX” are:
In the field “
Type
” the type of KNX is defined (fixd to ‘KNX TP’);
In the field “
ID Device
” the ID of the KNX side of the converter is defined.
The means of the fields for the “Modbus TCP Master” section are:
In the fields “
IP ADDRESS
” the IP address that you want to give to the Converter is defined;
In the fields “
SUBNET
Mask
” the SubNet Mask is defined;
In the fields “
GATEWAY
” the default gateway that you want to use is defined. This feature can
be enabled or disabled pressing the Check Box field. This feature is used for going out of the
net;
In the field “
TimeOut (ms)
” the maximum time that the device attends for the answer from the
Slave interrogated is defined;
In the field “
Cyclic Delay (ms)
” the delay (idle time) between two Modbus requests is defined.
Figure 3: “Set Communication” window
