Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
CANopen / KNX
Document code: MN67804_ENG Revision 1.001 Pagina 16 di 29
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, KNX and CANopen.
By Pressing the “
Set Communication
” button from the main window for SW67804 (Fig. 2) the window
“Set Communication” appears (Fig. 3).
The window is divided in three sections, one for the KNX, one for the CANopen and the other for
Ethernet.
The means of the fields for “KNX” are:
In the field “
Type
” the type of KNX is defined (fixd to ‘KNX TP’);
In the field “
ID Device
” the ID of the KNX side of the converter is defined.
The means of the fields for the “CANopen” section are:
In the field “
ID Device
” the ID of the CANopen side is defined;
In the field “
Baudrate
” the baudrate for the serial line is defined;
In the field “
Set Operational State at Start-up
” the state of the CANopen is defined. I.e. if it
is checked the board starts in Operational State, else it starts in Preoperational;
In the field “
Network Start at Start-up
” the state of the network CANopen is defined. I.e. if it
is checked the board sends a command to set the Operational State of all the devices present in
the network;
In the field “
Delay (s)
” the delay before sending the network command for the CANopen is
defined;
If the field “
SDO Client TimeOut (1/10 ms)
” insert a time. It is the maximum time that the
device attends for the answer from the Slave interrogated.
The means of the fields for “Ethernet” are:
In the fields “
IP ADDRESS
” insert the IP address that you want to give to the Converter;
In the fields “
SUBNET
Mask
” insert the SubNet Mask;
In the fields “
GATEWAY
” insert the default gateway that you want to use. This feature can be
enabled or disabled pressing the Check Box field. This feature is used for going out of the net.
Figure 3: “Set Communication” window