Adeunis RF LoRaWAN MODBUS MASTER ARF8240AA, Руководство пользователя, Страница: 54 / 80

EN
sigfox MODBUS MASTER - Guide utilisateur / User guide version V1.0.1
54 Page of 80
FR
2.2.4 TEST mode
This mode allows the user to perform tests on modifying the behavior of the LEDs.
It is obtained by positioning register S306 at the VALUE 2 in the COMMAND mode. Once out of the command mode, the product returns to the
previously defined application behavior but with the following changes:
- Register S300 : the periodicity of the Keep Alive is expressed in groups of twenty seconds instead of tens of minutes. Hence in test mode
when register 300 = 144, the Keep Alive is no longer sent every 144x10min=1440 minutes or 24h but every 144x20s=2880 seconds or 48
minutes.
- The LEDS also have a different behavior, allowing a visual feedback to the user in the event of transmission and reception of frames (see
paragraph 2.3 for more details).
A complete list of the registers can be found in paragraph 3.4.
E.g.:
Register Coding the VALUE VALUE Result
S306 Decimal 2 The product is in TEST mode
S300 Decimal 144 The Keep Alive frame is sent every: 144x20s i.e.
48 minutes
2.3. Operation of the LEDs
Mode LED red state LED green state
Transmission of frame (TEST mode only) ON during the transmission cycle
Reception of frame (TEST mode only) ON during the reception of a downlink frame
Product in Park mode OFF OFF
Magnet detection process (1 to 6 seconds) OFF ON from detection of the magnet up to a
maximum of 1 second
Product start (after detection of the magnet) OFF Rapid flashing 6 cycles, 100 ms ON / 100
ms OFF
Switching to the Command mode Continuously lit Continuously lit
Battery level low Flashing (0.5s ON every 60s)
Product faulty (return to factory) Fixed ON
Product in production mode (TEST mode
only) 50ms ON / 50 s OFF 50ms ON / 50 s OFF (just before the red
LED)
Product in REPLI mode Flashing (100ms ON / 100ms OFF) x 2 every 5s