AMR PULSE W-Mbus- Mode d’emploi / User guide version V1.3.1
37
Page
of 44
Once configuration of the product has been completed and its installation finalized, the product is ready to be started.
The product is started using a magnet placed on the upper part of the product (cf diagram below). The magnet must be kept in position for a
minimum of 6 seconds in order to confirm start-up of the product.
Once the AMR PULSE validates its start-up, it immediately transmits a data frame and history frames.
The AMR PULSE does not have an external LED showing its status. To make sure the product has started properly, we advise placing a data
receiver close to your product before start-up with the magnet. You can then receive the start-up frames and confirm that your product is opera-
ting properly.
IMPORTANT NOTE 1
: once the AMR PULSE has started, it can no longer be switched off.
IMPORTANT NOTE 2
: if the magnet is placed on it a second time, the AMR PULSE switches to CONFIGURATION mode. A 4 minute period
starts in which the product can no longer transmit. After these 4 minutes have passed, the product switches back to OPERATING mode.
Installation and use
3.6. Starting the product with a magnet
Compression gland nut
Position of the magnet for
product start-up
