Adept Audio IW62, Руководство по установке, Страница: 6 / 12

6
In-Wall Speaker Installation Manual
Installing the Speakers
When you’ve decided on the locations for all of the speakers, use the template to trace a circle lightly in pencil where
each hole should be. (If you don’t have a template, check the Specifications section for cutout sizes.) If you’re unsure on
whether there may be obstacles (such as pipes or wires) where you plan on installing the speaker, drill a 1/8 inch hole in
the center of the rectangle, then put a bent coat hanger through the hole to feel around. Use a keyhole or drywall saw to
cut the hole.
Painting the grilles
The grilles can be painted to match the color of walls or trim. The grille must be painted with spray paint, either from a
can or a sprayer. Before painting, carefully remove the thin cloth on the underside of the grille. Lightly spray the front of
the grille with the paint from a distance, being careful not to plug any of the holes. Diluting the paint with paint thinner
will lessen the risk of filling any holes. If a hole gets plugged, use a can of compressed air to open it. Once the paint is
dry, put the cloth back on the grille.
Connecting the speaker cables
To connect a speaker cable, first strip ½ inch of insulation from each conductor of the cable, and lightly twist the
exposed strands between your fingers to make sure there are no stray strands sticking out. Be sure to connect the
positive half of the cable (usually marked with a line on the side, or sometimes with red or white insulating jacket) to the
positive speaker cable connector, which is marked with a red dot. Press down on the speaker cable connector until a
hole appears in the side, then insert the stripped end of the cable and release the connector. Repeat with the other half
of the cable. Give each cable a light tug to make sure it’s secure.