ADENDORFF ZX6350G, Руководство по эксплуатации

Страница: 7 / 66

working table must be hoisted to the nearest position to the spindle when the
2 - blade milling tool is used.
6.
The spindle box that transmitted by the belt can be surivled at
90
°
( by gear
± 45
°) , when operating, pls loose the retaining nut and pay atten­
tion these nuts need only
1
pitch, then swivle screw lever by socket head­
screw wrench (
S21 - 24)
to make the spindle box swivle to the place re­
quired ( clockwise turn the nut, the spindle box will counter clockwise turn,
or otherwise) , while tun1ing, pls pay attention to the following item:
i : while the spindle ho� turn from horizontal postition or clined positon
to vertical position, pls help push the upper of spindle box and gently twitter
it.
ii: while the spindle box tum fron1 vertical position to horizontal posi­
tion or clined position, pls push the upper of spindle box with hand and
twitter it gently.
7. The cross - slide of spindle box can be realized through the ram
moving. For crossliding, pls firstly loosen the two cla1nping bolts@ locating
on the right side of the ram, turn the gear shaft
®,
to move the ram and
spindle box, and tight the two clamping bolts.
._,.,/
.
8. The spindle box can tum
360
°
around the column in he horizontal
..J
plane. To realize this, pls firstly loosen the 4 pcs of clamping nuts (
11 )
un-
der the ram, tun1 the ram to the suitable position, finally tight the 4 pcs of
clamping nuts.
9. The spindle's turn and revolve can be realized by the switch located
in right side of Hoist - descend sliding.
10.
The Horizontal milling can be realized by turn the vertical spindle
box
90
°
.
The spindle box must be tum
180
°
when the Tool shaft and jack
applied for assistance.
11.
If the machine doesn't work well or have irregular noise, pls imme­
diately shut off machine.
-6-