Settings on the RapidDome Dome Top Board
In the following section, please refer to below, for the locations on the board.
The RapidDome Dome Board
LED D2
will illuminate if the receiver that is being controlled by Coax Control is
selected by the transmitter and the coax control code is satisfactory. If the receiver is
being controlled by twisted pair control, LED D2 will flash whenever a valid
command is received.
L
K
1
OFF O
N
DILSW1
- Jupiter Microsphere
protocol, address
setting DIL Switch.
1
8
V C 4 4 5 V3
T
E
R
M
IN
A
T
IO
N
3 2 1
V C L
D2
- Sys OK LED
This LED is illuminated if the receiver is being
controlled by Coax telemetry and is selected by the
transmitter. If the receiver is being controlled by
twisted pair, it will flash whenever a valid telemetry
command is received.
