13
Configuration
Using the configuration menu
The configuration mode allows you to determine numerous aspects of the
AV4PRO-VGA unit capabilities.
To use the configuration menu
During normal use, the seven segment display on the front panel shows the
number of the currently selected computer channel. From this condition, enter
configuration mode as follows:
1 Press and hold the front panel
COMPUTER
button for roughly five seconds.
The display will show:
2 On the keyboard, press the letter key for the required menu section, e.g.
The display will show the pressed letter, e.g.
3 Press the number of the required setting, e.g.
The display will show the pressed number, e.g.
4 Press
to accept the setting and return to the main menu section.
The display will show:
5 You can now continue with your next configuration change (go to step 2),
or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• Press
and then press
to exit and save changes.
To exit the configuration menu without saving
• Press either of the front panel buttons.
Enter the OPTIONS port
Baud rate
menu
1200
(default)
38400
2400
57600
9600
115200
19200
Enter the
Functions
menu
Show current firmware version
Refresh EDID information from the connected video display
(default)
Use the stored EDID at startup, do not interrogate the video display
Reset configuration to factory defaults ( is displayed momentarily)
Enter the
Hotkey
menu
Ctrl + Alt
(default)
Alt
Ctrl + Shift
Left Ctrl + Alt
Alt + Shift
Right Ctrl + Alt
Right Alt
Hotkeys disabled
Enter the
Options port
behaviour menu
Channel switching via RS-232 serial control (using the baud rate set
by the ‘B’ option). Contact switching via the Options port disabled.
(d)
Channel switching via RC4 remote. Contact switching disabled.
As per but with contact switching enabled.
Set a new password for use with the lock mode
Enter the
Switch Mode
menu
All
(default)
KVM + Speaker
KVM only
Speaker only
USB1 only
USB2 only
Enter the
Autoscan Time Delay
menu
Autoscan disabled
15 seconds
2 seconds
30 seconds
5 seconds
(default)
1 minute
7 seconds
5 minutes
Enter the
User Preferences
menu
Enable mouse switching
(default)
Disable mouse switching
Cycle all ports (when using ‘ Tab’ or ‘Autoscan’)
(default)
Cycle only active ports (when using ‘ Tab’ or ‘Autoscan’)
You can press
at any point to exit
from an option and
return to the main
menu ( ) section.
(default)
or
(d)
denote
the default settings
for each group of
options.
HT
