ADC ECOWASH-MP2, Руководство пользователя и по обслуживанию, Страница: 32 / 34

32 113688- 1
5 MAINTENANCE
5.1 Electrical and mechanical
irregularities
Before calling the Technical Service Centrer, check
the following:
That power is supplied to the machine. The condition
of the fuses.
That the voltage is correct for the machine.
If the washing machine fails to get the required
level of water, check:
The water mains tap is open.
The water inlet filter is not blocked.
That the water pressure is between 2 and 4 kg/cm
2
(28 and 56 psi).
If the washing machine vibrates excessively, check:
That none of the panel screws are loose.
If a power cut occurs, check:
The tub is drained and the door is blocked. If you want
to take the clothes out of the washing machine, unlock
the door by pulling down the belt located behind the
control panel.
5.2 Error messages
On the washing machine screen, warning or fault
messages may be displayed during or after the
execution of a wash program. Except in the event of a
power cut, the washing machine will be paused (drain
pipe valve off, motor off, etc.), awaiting user action.
Message Possible causes Action
POWER
CUT
DETECTED
This message appears on recovering the power after having been
cut-off.
If the power cut occurs during the spin cycle, the message "WAIT" is
displayed. For safety reasons, wait approximately 1.5 minutes
without pressing anything until "PWR FAULT" is displayed.
Press START: the program continues to
operate in the same phase as before the
power cut.
Press EXPRESS: the program ends.
E2
FAULT LOCK
This message appears when it is detected that the door can not be
unlocked at the end of the program or that it has unlocked during the
program
Press ESC: the program ends.
E3
FAULT DRAIN PIPE
This message is displayed when, in spite of deactivating the
emptying valve output, the water level inside the drum has not
decreased for a pre-established period of time.
Press START: the program continues.
Press EXPRESS: the program ends.
E4
FAULT WATER INLET
This message appears when, in spite of activating the
corresponding solenoid valves' outputs, the water level inside the
tub has not increased during a certain pre-established period of
time.
Press START: the program continues.
Press EXPRESS: the program ends.
E5
HEATING FAULT
This message is shown when, in spite of activating the heating
output, the water temperature has not increased for a certain pre-
established period of time.
Press START: the program continues.
Press EXPRESS: the program ends.
E6
MAX. TEMP
This message is displayed when the water temperature has
exceeded 95 ºC.
Press START: the program continues.
Press EXPRESS: the program ends.
E7
THERMOSTAT OPEN
This message appears when the water exceeds 95 ºC
Press START: the program continues.
Press EXPRESS: the program ends.
E9
MOTOR HEATING
This message appears when the thermal protection of the washing
machine's motor is detected to have not been activated.
Press START: the program continues.
Press EXPRESS: the program ends.
E10
UNBALANCE
This message appears when the final spin activates the unbalance
micro three times.
Press EXPRESS: the program ends.
E11
CLOTHES HOT
This message is displayed when a program execution finishes but
the water temperature inside the tub exceeds 50 ºC.
Press EXPRESS: the program ends.
E12
WATER IN TUB
This message is displayed when a program execution is finished but
there is still water inside the tub. The door can not be opened until
the water is drained from the tub.
Press EXPRESS: the program ends.