Once you have set the minutes and pressed the «
TIME
» button, the date and time are set and the time is
4.
displayed.
NOTE
If you want to change the date and time, press and hold the «
TIME
» button down for approx. 3 seconds
•
until the user icon starts to flash. Press the «
TIME
» button again; now you can enter the new values as
described above.
A single press of the «
MEMORY
» button or «
TIME
» button advances one operation.
•
Holding the button down speeds up the procedure.
•
5.3. Select the User
This blood pressure monitor is designed to store 99 measurements for each of two users. Before taking a
measurement, be certain that the correct user has been selected.
With the unit off, press and hold the «
TIME
» button to cycle between users ("1" and "2").
1.
Press the «
MEMORY
» button to toggle between users.
2.
Press the «
ON/OFF
» button to make your selection.
3.
5.4. Selecting the Measurement Mode (6016N only)
This instrument enables you to select either standard (single measurement) or measurement
averaging mode (automatic triple measurement).
To select Standard mode, push the switch on the side of the instrument to position “1”.
1.
To select Averaging mode, push the switch to Position "3."
2.
Note: The MAM Advantage™ Averaging mode icon will illuminate on the display.
3.
If you select 1, then only one measurement will be taken. If you select 3, the unit will inflate
and deflate three times resulting in one final average.
5.5. Using ADC Average Mode Technology (6016N only)
In MAM Advantage™ Averaging mode, three measurements are automatically taken in
1.
succession and the result then automatically analyzed and displayed. Because your blood
pressure constantly fluctuates, a result determined in this way is more reliable than one
produced by a single measurement.
After pressing the «ON/OFF» button, the MAM Advantage™ Averaging mode icon
2.
appears in the display.
The bottom right hand section of the display shows a 1, 2, or 3 to indicate which of the 3
3.
measurements is currently being taken.
There is a break of 15 seconds between the measurements (15 seconds are adequate according
4.
to “Blood Pressure Monitoring, 2001, 6:145-147” for oscillometric instruments). A countdown
indicates the remaining time.
The individual results from measurements 1, 2 and 3 are not initially displayed.
5.
NOTE:
If you want to see each of the individual readings making up a triplicate reading, turn
the unit off, then press and hold the Memory button for 3 seconds, until you hear a tone,
immediately after a MAM Advantage™ Averaging Mode measurement.
Note:
You can only see the individual readings one time immediately following an Averaging
Mode measurement.
Do not remove the cuff between measurements.
6. MEASUREMENT PROCEDURE
6
0
1
6
N
M
o
d
e
l
O
n
l
y
