36
I. PREPARATION FOR OPERATION/START-UP
The following items
should be
checked before attempting to operate the dryer:
1. Read
ALL
"
CAUTION
," "
WARNING
," and "
DIRECTION
" labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label
affixed to the back side of the top front control/service door. In the case of 208 VAC or 230/240
VAC,
THE SUPPLY VOLTAGE MUST MATCH THE ELECTRIC SERVICE EXACTLY
.
3.
GAS MODELS
- check to assure that the dryer is connected to the type of heat/gas indicated on the
dryer data label.
4.
GAS & ELECTRIC MODELS
-the sail switch damper assembly was installed and adjusted at
the factory prior to shipping. However, each sail switch
adjustment
must be
checked to assure that this important safety
control is functioning.
(see
page 37
for Sail Switch Adjustment)
5.
GAS MODELS
- be sure that
ALL
gas shut-off valves are in the open position.
6. Be sure
ALL
side and base panels are on the dryer.
7. Check
ALL
service doors to insure that they are closed and secure.
8. Be sure the lint door is securely in place.
9. Rotate the basket (tumbler/drum) by hand to be sure it moves freely.
10.Check bolts, nuts, screws, terminals, and fittings for security.
11.STEAM MODELS - check to insure air supply (80 PSI) is connected to the dryers.
12. STEAM MODELS - check to insure
ALL
steam shut-off valves are open.
13. STEAM MODELS - check steam damper operation.
14.Check tumbler bearing set screws to insure they are
ALL
tight.
