ENGLISH
10
9.2.2.
Using J-bolts
Before anchoring the machine to the floor, make sure that its minimum resistance is equal or higher than 3600 psi
(25N/mm2).
First mark the points at which the holes are to be made, using the dimensions specified in the plans on page 12.
Next make holes to a depth, at minimum, equal to 3,9 inch (100mm). Make the holes big enough to insert the J-bolt
and clean using compressed air. Insert the J-bolts in the holes and secure using a suitable anchoring compound,
ensuring that the bolt protrudes above the surface by 2,4 inch (60mm). Be sure to use M16 J- bolts.
Place the washer-extractor in position above the bolts, and gradually tighten the nuts one after another until the
machine is securely fastened.
Check the condition of the J-bolts one week after installation.
