Page 20
Rev. : 002
HF - VISION 10 & PHOENIX
Lighting Technologies
6.2.1.6 Terminal ID
In the case of several satellites being connected in one and the same operating
range to different desks, it is necessary to chose a different terminal / transmitter
address for each transmitter.
The terminal default value 1 can be changed to address between 2 and 100.
Key sequence:
Display :
II
11:15
M E N U
M E N U = EXIT
TERM ID No. : 001
UP & DN TO SEL
Every transmitter / terminal can be set to a special terminal ID address which is
scanned by any receiver connected. This function is optional and is only of use when
several satellites are connected to several desks.
You can increase the number up to 100 by using the keys up'
↑
and 'down'
↓
.
Default terminal ID is 1.
6.2.1.7 Beep
Key sequence:
Display :
II
11:15
M E N U
M E N U = EXIT
ADJUSTEMENTS
BEEP : ON
UP & DN TO SEL
This sub-menu is used to switch the acustical key click and the send feedback
signal ON or OFF. When BEEP is set ON, every push on a key provokes an
acoustical key click on the sender's built-in speaker, and furthermore a beep signal
is issued when the key code(s) entered were received correctly from a receiver.
Default is beep 'ON'. You can toggle beteen the beep possibilities "ON" and "OFF"
by using the keys up'
↑
and 'down'
↓
.
MENU
→
→
→
→
→
5
→
→
→
→
→
MENU
6
