3.0 Installation
Before beginning installation:
•
Determine where to place the PLC cabinet and touchscreen computer.
•
Verify the cable run between the PLC cabinet and the computer, is within 9 feet (3 m) or construct an extension cable that
meets the requirements set forth in the print package. For a standard PLC cable extension, please refer to drawing
43A4380-02 for pin-out details.
•
If the communication medium between the computer and the PLC cabinet is longer than 9ft. a communication extension
option may be purchased. These options include hardwire communication equipment with lightning protection, multi-
mode or single-mode fiber optic communication media converters, or 2.4 GHz serial radios. Refer to the print package for
equipment details.
•
Ensure there is access for power and control wiring.
3.1 Mounting the Touchscreen
Touchscreens are available in either flush-mount or desktop stand-alone units. The standard version of the NAVIGATOR comes
with a 12” touchscreen computer that can be both flush mounted or mounted to a desktop stand.
3.1.1 Flush Mount Touchscreen
Determine where to mount the flush mount touchscreen in the ATCT.
•
Make sure that there is ample space available around and below the mounting area. Please see the NAVIGATOR system
prints for dimensions. The 12” panel cutout dimensions can be found on drawing 105A0863. The optional 15” panel can
be found on drawing 105A0870/L157 (drawing 105A0870 for older installations).
•
Cutout the console area to fit. Place the touchscreen down in the console making sure that the bezel catches on the
outside of the cutout for a flush fit.
•
The power cord will be attached underneath the screen when it is mounted and should be plugged into critical power in
the ATCT.
•
Refer to 105A0863 for specific touchscreen computer port connections. These will vary depending on the options
purchased so please take care in making these connections.
•
All cabling going to the touchscreen should have adequate strain relief installed so that the cables and connections will
not be under any stress.
3.1.2 Desktop Stand-alone Touchscreen
Determine where the Stand-alone touchscreen is to be set up in the ATCT.
•
Make sure there is a flat surface for the touchscreen to be set on to ensure stability.
•
The power cord will be attached to the back of the monitor and must be plugged into critical power in the ATCT.
•
Refer to 105A0863 for specific touchscreen computer port connections. These will vary depending on the options
purchased so please take care in making these connections.
3.2 Mounting the Equipment
The PLC cabinet must be installed indoors, protected from excessive heat, cold and dampness. The cabinet must be secured
to a structure that will support its weight (137lb. / 62kg). See cabinet specifications for details.
Provide adequate clearance around the cabinet for connecting control and power cables. Enough clearance must be left in
front of the cabinet to open the door safely for service.
See Drawing 44A7675-01 for dimensions, mounting details, and suggested mounting height.
96A0363, Rev. i, 2019/10/31
11
Copyright
©
ADB Safegate, All Rights Reserved
