Adaptiv P0101, Руководство пользователя

Страница: 6 / 12

will be displayed for 1 second, and the detected radar or laser signal will return to the LCD
display.
When this button is pressed for 2 or more seconds, it will toggle the backlight on the Main
Unit buttons on/off.
Up and Down Buttons (upper and lower right buttons)
The
“
Up
”
and
“
Down
”
buttons control the volume of the Main Unit and the Headset, and
the LED brightness of the Visual Alert. When each is pressed for 1 or more seconds, the
increase or decrease in the volume/brightness will increase or decrease continuously until
the maximum or minimum volume level is reached. The system will remember the last
volume setting each time it is turned on, except for the Visual Alert, where auto-setting is
the default (explained below).
When
“
Headset Control Mode
”
is selected, the
“
Up
”
and
“
Down
”
buttons control the
volume on the Main Unit and the Headset. For each level the volume is raised/lowered,
the Main Unit and the Headset will emit a corresponding volume. The display is as
follows:
The Main Unit has a photo-sensor and it automatically controls the brightness setting on
the Visual Alert. The auto-setting is the default setting on the Visual Alert each time the
unit is turned on. However, it can be over-ridden by the user with a push of the
“
Up
”
or
the
“
Down
”
button if
“
Visual Alert Control Mode
”
is selected. When
“
Visual Alert Control
Mode
”
is selected, the
“
Up
”
and
“
Down
”
buttons control the LED brightness on the Visual
Alert. Each time the button is pressed, the Main Unit will emit a beep and the Visual Alert
will double flash a corresponding brightness. The auto-setting function can be turned
back on by the user by select the
“
lowest
”
setting on the
“
Down
”
button. The display is
as follows:
Other:Tx Opertion
The Main Units must operate properly and not interfere with each other when multiple units
are being used in the same vicinity (>2m).