Adaptec 2940UW PRO, Руководство пользователя, Страница: 23 / 38

13
Configuring the SCSI Card 2940UW Pro with SCSISelect
Configuring the SCSI Card
2940UW Pro with SCSI
Select
SCSISelect, included with the SCSI Card 2940UW Pro, enables you to
change SCSI settings without opening the computer or handling the
card. SCSI
Select also enables you to low-level format or verify the
disk media of your SCSI hard disks. Table 1 lists the available and
default settings for each SCSI
Select option.
Note:
The default settings are appropriate for most systems.
Run SCSI Select if you need to change or view current
settings, or if you would like to run the SCSI disk utilities.
See the descriptions of each option starting on page 16.
Table 1. SCSI Select Settings
SCSI Select Options Available Settings
Default
Setting
Basic Host Adapter Options:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination:
Narrow Connector Enabled, Disabled Enabled
Wide Connector Automatic, Enabled,
Disabled Automatic
Boot Device Options:
Boot Target ID 0-15 0
Boot LUN Number
1
0-7 0
SCSI Device Configuration Options:
Sync Transfer Rate (MBytes/sec) 40.0, 32.0, 26.8, 20.0,
16.0, 13.4, 10.0, ASYN 40.0
Initiate Wide Negotiation Yes, No Yes (Enabled)
Enable Disconnection Yes, No Yes (Enabled)
Send Start Unit Command Yes, No Yes (Enabled)
Enable Write Back Cache Yes, No, N/C N/C (No
Change)
BIOS Multiple LUN Support Yes, No No (Disabled)