37
Exiting SCSISelect
2
Use the
↑
and
↓
keys to move the cursor to a specific ID and
device, then press
Enter
.
3
A small menu appears, displaying two options:
■
Verify Disk Media
—Allows you to scan the media of a hard
disk drive for defects. If the utility finds bad blocks on the
media, it prompts you to reassign them; if you select yes,
those blocks are longer used. You can press
Esc
at any time
to abort the utility.
■
Format Disk
—Allows you to perform a low-level format on
a hard disk drive. (Most SCSI disk drives are preformatted at
the factory and do not need to be formatted again.) Each
hard disk drive must be low-level formatted before you can
use your operating system’s partitioning and file
preparation utilities, such as MS-DOS Fdisk and Format.
Caution:
A low-level format destroys all data on the drive.
Be sure to back up your data before performing this operation.
You
cannot
abort a low-level format once it is started.
Therefore, do not turn power off to abort this operation.
Exiting SCSI
Select
To exit SCSI
Select
:
1
Press
Esc
until a message prompts you to exit.
If you changed settings, you are prompted to save the changes
before you exit.
2
Select
Yes
to exit, then press any key to reboot the computer. Any
changes you made in SCSI
Select
take effect after the computer boots.
!
Содержание 2906 - SCSI Card Storage Controller Fast 10 MBps
Страница 1: ...R USER S GUIDE ADAPTEC SCSI CARD 2906 ...
