6
English
4. Indicator on the charger lights orange when charging. If the rechargeable
battery is fully charged, indicator lights green.
5. It’s possible to remove batteries from the tool. Unscrew screws in the
battery compartment cover (№3 рic.1).
IMPORTANT: You can operate with the tool while it is charging.
Detector
1. Press the fixator on the battery compartment and remove the battery
compartment cover.
2. Remove battery 9V.
3. Insert new battery 9V. Obsurve the polarity. Close the battery compart-
ment cover.
Remote control
Battery compartment is located on the back side of the remote control.
1. Remove the battery compartment cover.
2. Remove batteries.
3. Insert batteries type “AAA”. Obsurve the polarity. Close the battery com-
partment cover.
It’s possible to use a remote control for the operation with the laser level.
Distance range of the remote is 20m.
OPERATING MODES
INSTALLING THE LASER LEVEL
Place the tool on the stable support in horizontal or vertical position.
The tool can compensate a tilt automatically up to ± 5°.
NOTE: to project vertical plane in automatic mode, place the tool with
keypad up.
Use
5/8″ (at the bootom or on the side of the tool) thread to set a tool on
the tripod. For precise positioning above the target location, use the plumb
down point. Due to its high accuracy, the device reacts very sensitively to
vibrations and changes in position.
HORIZONTAL/VERTICAL PLANE (AUTOMATIC MODE)
1.
Press button ON (№2 pic.2). Power indicator (№1 pic.2). Shock warning
Indicator (№12, pic 2) will blink. If the tool is out of range (±5° ), the
Manual indicator (№6, рic.2) and laser diode will start blinking, rotation
