Acute TravelLogic, Руководство пользователя

Страница: 45 / 58

45
Acute Technology Inc.
Copyright

2018
DHCP is set to OFF. If the IP setting does not take effect, please disable and then enable the
network, or reboot to make the network settings effective.
Test Connection / Connection Status
It can be used to connect the oscilloscope / display the current stack oscilloscope model and
automatically add the oscilloscope channel to the waveform window.
Screen of oscilloscope stack
Oscilloscope is set as the master, while the TravelLogic is set as the slave
If the stack is composed of the oscilloscope as the master and TravelLogic as the slave, you
must not only complete the above-mentioned basic settings but also set the external trigger
signal. For the hardware wiring, please refer to Figure 2. Press "Trigger Condition" →
"External Trigger", as shown below.
Stack Delay
When TravelLogic is triggered successfully, the Trig-Out signal is transmitted through Cable
to the DSO with a time delay, resulting in a deviation between the logic and the analog signal
time displayed by the waveforms. Therefore, the stack delay time must be set to compensate
the delay. In the waveform display screen, you can put the mouse on the top of the DSO