Lights
Replacing Side Marker Bulbs
1. Use your fingernail to lift the
rubber seal along the back edge of
the side marker lens.
2. Use a small flat blade screwdriver
under the rubber seal to pry
carefully on the back edge of the
side marker assembly until it pops
out of the body.
3. Remove the electrical connector
from the bulb holder by squeezing
the connector and pulling them
apart.
4. Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens.
5. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
6. Put the bulb holder back into its
hole in the lens, and turn it clock-
wise until it locks.
7. Plug the wire harness back into
the bulb holder.
8. Turn on the parking lights and
check that the new bulb is work-
ing.
9. Put the side marker assembly
back into the body, front first.
Push on the back edge until it
snaps into place.
Maintenance
RUBBER SEAL
FLAT BLADE
SCREW DRIVER
BULB HOLDER
CONNECTOR
Содержание 1995 NSX
