6 of 12
BII 46119 (1108)
©
2011 American Honda Motor Co., Inc. - All Rights Reserved.
24. Install the two corner sensors A and clips A into
the outer holes and two center sensors B and
clips B into the inner holes on the rear bumper.
22. While wearing eye protection, drill a 3 mm pilot
hole through the outside surface of the rear
bumper at each of the eight pierced points you
just made.
NOTE: The top 3 mm hole locates the direction of
the sensor.
23. While wearing eye protection, enlarge the lower
hole at each of the marks using a 24 mm hole saw
(outer holes) and a 26 mm hole saw (inner holes).
Remove all burrs.
5D27090B
(outside)
VEHICLE
GROMMET
Discard.
BACK-UP
SENSOR
HARNESS
(cabin side)
BACK-UP
SENSOR
HARNESS
GROMMET
FRONT
4 BACK-UP
SENSOR HARNESS
2-PIN
CONNECTORS
5D27070B
REAR
BUMPER
DRILL
(3 mm DRILL BIT)
DRILL
(3 mm DRILL BIT)
DRILL
(3 mm
DRILL BIT)
DRILL
(26 mm HOLE SAW)
DRILL
(3 mm DRILL BIT)
2 UPPER
MARKS
2 LOWER
MARKS
2 UPPER
MARKS
DRILL
(24 mm HOLE
SAW)
2 LOWER
MARKS
25. Inside the tailgate opening, locate and remove the
vehicle grommet.
5D27082B
2 CLIPS A
REAR
BUMPER
24 mm
HOLE
2 CENTER
SENSORS B
REAR
BUMPER
2 CLIPS B
REAR
BUMPER
2 CORNER
SENSORS A
2 CORNER
SENSORS A
2 CENTER
SENSORS B
OUTSIDE SURFACE
OF THE REAR BUMPER
INSIDE SURFACE OF
THE REAR BUMPER
26 mm HOLE
OUTSIDE SURFACE
OF THE REAR BUMPER
INSIDE SURFACE OF
THE REAR BUMPER
