12 of 12
BII 46119 (1108)
©
2011 American Honda Motor Co., Inc. - All Rights Reserved.
49. Check that all wire harnesses and cables are
routed properly and that all connectors are plugged
in.
50. Reinstall all removed parts.
51. Reconnect the negative cable to the battery.
52. Enter the anti-theft codes for the radio and
navigation systems, then enter the client's radio
presets.
53. Check that the back-up sensors work properly as
described in the Accessory User's Information
Manual.
54. Reset the driver's window AUTO UP/DOWN
function:
• Start the engine. Push down on the driver's
window switch until the window is fully open.
• Pull on the driver's window switch to close the
window completely, then hold the switch to close
the window completely, then hold the switch for
1 second or more.
• Lower and raise the driver's window to check
operation of the AUTO UP/DOWN function.
48. With an assistant holding the rear bumper near the
vehicle, plug in the four back-up sensor harness
2-pin connectors.
6106040B
REAR
BUMPER
CENTER
LARGE
SENSOR B
CORNER
SMALL
SENSOR A
4 BACK-UP
SENSOR
HARNESS 2-PIN
CONNECTORS
CORNER
SMALL
SENSOR A
CENTER
LARGE
SENSOR B
