4 of 22
BII 45421 (1103)
© 2011 American Honda Motor Co., Inc. – All Rights Reserved.
6.
Using isopropyl alcohol on a shop towel, clean the
control unit where the protective tape will attach.
Remove the adhesive backing, and attach the
protective tape to the control unit over the switch
opening.
7.
Lower the tilt lever and pull the steering wheel out.
Remove the two lower self-tapping screws and the
lower screw.
8.
Turn the steering wheel as necessary to access
each self-tapping screw, and remove the two self-
tapping screws.
772505AS
CONTROL
UNIT
SWITCH
OPENING
PROTECTIVE
TAPE
ADHESIVE
BACKING
Clean with
isopropyl alcohol.
830618BT
SELF-TAPPING
SCREWS
LOWER
SCREW
LOWER
SELF-TAPPING
SCREWS
TILT
LEVER
9.
Remove the upper steering column cover and the
lower steering column cover:
•
Starting with the left side, use a small flat-tip
screwdriver to push in to release the tab, then
push in on the side of the upper steering column
cover in the area shown to release the rear tab.
•
Shift the column covers to the right, and repeat
the same procedure.
•
Release the four hooks, and remove the upper
steering column cover and the lower steering
column cover.
830617BT
SMALL FLAT-TIP
SCREWDRIVER
(Push on tabs.)
Push.
Push.
2 REAR TABS
2 HOOKS
2 HOOKS
UPPER STEERING
COLUMN COVER
LOWER STEERING
COLUMN COVER
