The Remote Transmitter
3
Ignition key
The system is supplied with 2 transmitter/Ignition keys, if a new
transmitter is supplied, a new key can be attached as shown in the
diagram opposite.
When all three buttons are pressed at once and held
for 5 seconds
W
Wiitth
h iig
gn
niittiio
on
n o
offff - Silent arm/disarm is toggled (14 flashes on/7 off)
W
Wiitth
h ssyysstte
em
m a
arrm
me
ed
d o
orr d
diissa
arrm
me
ed
d - on/off
W
Wiitth
h iig
gn
niittiio
on
n o
on
n,, ssyysstte
em
m d
diissa
arrm
me
ed
d - Nudge sensor toggled on/off
(6 flashes on/3 off)
W
Wiitth
h iig
gn
niittiio
on
n o
offff,, ssyysstte
em
m iin
n sse
errvviic
ce
e m
mo
od
de
e - Indicators on warning
function is toggled on/off (5 flashes on/10 off)
Standard Settings of the system
When the system arms, immobilisation and hot wire (ignition circuit
becomes live) functions only will be enabled.
The system will arm automatically 50 seconds after the ignition is
switched off. (this time cannot be altered)
You can manually arm the system by pressing the lock button. (You will
get 2 beeps and 2 flashes of the indicators) (see section 6)
To disarm the system, press the lock button. (You will get 1 beep and 1
flash of the indicators) (see section 6)
The system will arm with an audible warning of arming.
T
Th
hiiss b
bu
utttto
on
n w
wiillll;;
•
Deactivate/activate tilt
and vibration,
•
Select siren tone,
•
Select number of
digits in PIN
T
Th
hiiss b
bu
utttto
on
n w
wiillll;;
•
Arm & disarm the system,
•
Allow you to enter Diagnostic
and Service Modes.
T
Th
hiiss b
bu
utttto
on
n w
wiillll;;
•
Activate the torch
T
Th
hiiss b
bu
utttto
on
n w
wiillll;;
•
Allow the ignition key
to swivel out
These screws (x2)
attach the ignition
key to the transmitter
Undo these screws (x3)
to remove cover and
replace batteries
Replacement battery type CR2016
