Troubleshooting
10
The Acumen CAT21 is manufactured using automotive specification
parts, including a waterproof connector, and is fully encapsulated to
provide protection against water and vibration. The system relies on
various signals to make it function correctly and any one of these
signals may cause false reactions.
FFa
allsse
e a
alla
arrm
mss;; E
En
ntte
err d
diia
ag
gn
no
ossttiic
c m
mo
od
de
e tto
o sse
ee
e w
wh
hyy tth
he
e a
alla
arrm
m h
ha
ass
ttrriig
gg
ge
erre
ed
d..
2 beeps. Blown fuse - Replace. If it blows again contact the installing
dealer.
3 beeps. The unit has detected an ‘hotwire’ signal.
4 beeps. The movement or nudge sensor has reacted. Enter
Convenience Mode (Section 2) to remove this function until the
problem is sorted.
5 beeps. Anti tamper switch - ensure it is mounted correctly.
S
Syysstte
em
m c
ca
an
nn
no
ott b
be
e a
arrm
me
ed
d o
orr d
diissa
arrm
me
ed
d b
byy tth
he
e rre
em
mo
otte
e ttrra
an
nssm
miitttte
err
1. Check the ignition switch is in the off position
2. Check the system fuse
3. Check you are within normal operating range of the motorcycle
(10 metres max)
4. Check the condition of the transmitter battery
5. The transmitter can be affected by other radio sources. This
problem can usually be overcome by placing the transmitter as
close as possible to the alarm system. Alternatively, you can move
the motorcycle a distance which will reduce the affect of the
interference. In this event you can disarm the system by using the
PIN.
