ACU-RITE 200S READOUTS, Справочное руководство

Страница: 66 / 82

52 I
II - 1 Installation Set
u
p
Serial Port
A printer or computer may be connected to the serial port. Job, and
Installation Setup parameters may be sent to a printer or computer.
Remote commands, remote key codes, and Job, and Installation
Setup parameters may be received from a computer.
 The BAUD Field can be set to 300, 600, 1 200, 2 400, 9 600, 19 200
38 400, 57 600, or 115 200 by using the soft keys.
 The parity can be set to NONE, EVEN, or ODD using the LOWER, or
HIGHER soft key.
 Data Bits in the Format Field can be set to 7, or 8 using the
soft key provided.
 The Stop Bits Field can be set to 1, or 2 using soft key.

Line Feed Field can be set to YES if the external device needs a line
feed to follow a carriage return.
 Output tail is the number of carriage returns that will be sent at the
end of the measured value output transmission. The output tail is
initially 0, and can be set to a positive integer value (0 - 9) by using
the numeric hard keys.
The serial port settings will be retained on a power cycle. There is no
parameter to enable, or disable the serial port. Refer to Data Interface
section for cable connection, and pin assignments.
Counter Settings
The COUNTER SETTINGS feature is the parameter where the
operator defines the user application for the readout. The choices are
for milling, or turning applications.
A FACTORY DEFAULT soft key appears in the Counter Settings
choice of options. When pressed, the configuration parameters
(based on either mill, or turn) will be reset to factory defaults. A
responses of YES to set parameters to factory default settings, or NO
to cancel, and return to previous menu screen is required.
The Number of Axes field sets the number of axes needed. A 1, 2, or
3 soft key will appear to choose between either 1, 2 or 3 axes.