ActSafe PME, Руководство пользователя

Страница: 24 / 32

24
THE ROPE GRAB
It is normally not necessary to remove the rope grab for inspection unless it has been
exposed to abnormally dusty or dirty environment.
However, in case it should be necessary to clean the machine and its rope grab, please
observe
the following instructions:
1.
The rope grab can be demounted and replaced only together
with the drive shaft. The rope grab and the drive shaft form a
unit.
Loosen the two M6 nuts (1.) that are situated inside the
textile bag. Remove them and the Nord-lock washers. The
loop, and the guard which is mounted on the loop, can now
be removed.
The “guide knife” which is also connected to the loop is
thereby removed.
After cleaning, re-lubricate the gear ring and gear wheel with
water-proof grease (similar to gear grease).
Replace the guide knife and the loop and fasten the two M6
nuts at 11 Nm. Make sure that the Nord-lock washers are
mounted in the same way as before. These are special
washers with high resistance against vibration.