ActronAir RC-03, Руководство по эксплуатации

Страница: 11 / 16

Operation Manual - RC-03 Controller
Document: 9590-4017 Ver. 1 220318
Operation Manual
Remote Controller
11
06. How To Use Advanced Function
06.01. VANE Function (not available for Mini-Cassette)
Press
Vane
button when the unit is turned on.
4 Louvers
Press
Vane
button to activate the louver setting feature. Each time you press the
Vane
button, the display panel will
display the selected louver in an order as(“-0” indicates that four louvers are all selected):
-1 -2 -3 -4
-5
Press Swing button to start/stop the auto swing feature of the selected louvers.
NOTE
The system will exit the louver setting mode If there is no operations during a 10 seconds period.
06.02. SWING Function
Press button
The horizontal louver auto swing feature is energized.
Press again to stop the swing.
06.03. LED Display
1. Press the LED button to activate or de-activate the display on the indoor unit.
2. Press and hold the LED button for more than 5 seconds until it beeps, release. Then press and hold again for 5
seconds then release after beeps.
3. After few seconds the room temperature shows.
4. To revert to previous display, repeat steps 2 and 3. To revert the change press
LED button until set point shows
on the indoor unit.
06.04. QUIET Function (not available for Mini-Cassette)
1. Press and hold the button for more than 2 seconds to activate Quiet Function. Quiet icon will display to
indicate it is activated. The compressor will run at a reduced capacity to minimize the operational noise.
NOTE
Due to low compressor frequency operation, this may result in insufficient cooling and heating capacity.
2. Holding button again for 2 seconds turns off quiet function.
3. Pressing the button will also cancel Quiet Mode.