8
INSTALLING THE UNIT
•
To Reduce the Risk of Electric Shock – DO NOT use in wet or damp
locations; this equipment emits UV-C radiation; DO NOT locate
equipment in any location allowing direct line-of-sight to vents,
returns, or other duct openings; disconnect from supply before
servicing or replacing
•
If installed near a furnace or where emergency heat coils could raise
the temperature inside the plenum, cycle the AC unit through three
full heating cycles assuring that the temperature never exceeds
200
°
F (93
°
C); the ActivePure
®
Cell must not exceed 200
°
F (93
°
C)
WARNING
• When the unit is installed in a roof mounted HVAC system, the unit
must be protected from elements
• This unit is equipped with a universal ballast that operates at nominal
voltages between 100 and 277 VAC, 50/60 Hz
• Unit requires power 24/7; DO NOT install where power to the unit will
be cycled on and off
CAUTION
3 . Using the mounting plate as a
template, mark the location
for installation .
4 . Use a hand saw or tin snips to cut a
10” x 6 .5” rectangle .
OR
Find the optimal position downstream from the air handler . Ensure location in duct has enough room for the
mounting plate . It is recommended for maximum effectiveness that the unit be placed as close to the air
handler as possible .
1 . Locate suitable area of duct
for installation .
2 . Cut away insulation to expose
metal duct (if needed) .